Difference between revisions of "CombiCam"
From CunningWiki
m (Created page with "'''Installing the CombiCam''' '''Common Mistakes''' '''Instructions for Changing combination'''") |
m |
||
| Line 1: | Line 1: | ||
'''Installing the CombiCam''' | '''Installing the CombiCam''' | ||
| + | *Insert lock body through the front of the 3/4" drilled hole | ||
| + | *(Wood Only) Place prong washer over lock body, prongs facing wood. | ||
| + | *Thread Cylinder Nut and tighten. | ||
| + | *Attach stop cam (square piece with one round side and square hole) | ||
| + | *Attach straight cam (long piece with square hole) | ||
| + | *Secure with screw & lock washer (one piece) | ||
| − | |||
'''Instructions for Changing combination''' | '''Instructions for Changing combination''' | ||
| + | *The default combination is 0-0-0 | ||
| + | *Set combination to the open number | ||
| + | *Locate a small hole on the outside of the lock | ||
| + | *Press a paper clip into this hole to press the reset button | ||
| + | *Rotate the combination to the new number | ||
| + | *Release the reset button | ||
| + | |||
| + | '''Your Lock is now set!''' | ||
| + | |||
| + | '''How to permanently set a combination''' | ||
| + | *Take off the screw to the cam and remove the "cam" and "stop cam" | ||
| + | *Rotate cylinder 180 degrees & put "stop cam" and "cam" back on | ||
Revision as of 18:46, 14 March 2012
Installing the CombiCam
- Insert lock body through the front of the 3/4" drilled hole
- (Wood Only) Place prong washer over lock body, prongs facing wood.
- Thread Cylinder Nut and tighten.
- Attach stop cam (square piece with one round side and square hole)
- Attach straight cam (long piece with square hole)
- Secure with screw & lock washer (one piece)
Instructions for Changing combination
- The default combination is 0-0-0
- Set combination to the open number
- Locate a small hole on the outside of the lock
- Press a paper clip into this hole to press the reset button
- Rotate the combination to the new number
- Release the reset button
Your Lock is now set!
How to permanently set a combination
- Take off the screw to the cam and remove the "cam" and "stop cam"
- Rotate cylinder 180 degrees & put "stop cam" and "cam" back on
