Dual Servo Controller Assembly Instructions

From CunningWiki
Revision as of 20:43, 14 January 2012 by Ilya (Talk | contribs)

Jump to: navigation, search

Before you begin soldering, spread out the parts you've received and make sure you have everything. You should have all the following components:

Tiny Servo Driver 42.JPG

For detailed information about each component check out the Tiny Servo Driver Bill of Material.


Now that you have everything lets begin. First, insert the the resistor into the PCB. Resistors are non-polar so they can be inserted in any orientation. To make to easier to insert the resistor, bend it into a staple shape, like this:

Tiny Servo Driver 01.JPG


Once the resistor is inserted, bend out its leads so that it stays in place.

Tiny Servo Driver 02.JPG


Next insert the diode. The diode needs to be inserted the correct orientation. Make sure that, once inserted, the stripe on the diode matches up with the stripe on the PCB graphic.

Tiny Servo Driver 03.JPG


Once you insert the diode, bend out its leads so that it stays in place.

Tiny Servo Driver 04.JPG


Insert the capacitor.

Tiny Servo Driver 05.JPG


And bend out its leads to keep it in place.

Tiny Servo Driver 06.JPG