I cant upload any sketch with your library into my attiny85 with arduino as ISP
could you help me to fill up the makefile? where can I find how to refer to my port?
and the directory of my arduino is too long, it gives me an error when compiling and if i dont pur nothing it compiles but I can’t upload…
I dont know what to do! thank you very much
I found the 0.6 version running on an ATtiny85 with internal 8MHz clock works fine. However, when I replace the .h/.cpp files with the 0.7 version, the servo doesn’t run. I didn’t change any code in the .ino file. Any idea what is happening?
A separate question is regarding the 0.6 library version. When I use the same control program logic and compare the servo operation between standard arduino servo library and your 8-bit library I get a little jumping of the servo rather than a smooth sweep I get from the standard library. Can you explain why this would happen?